A 0.3m CAT6A Ethernet patch lead rated to 500MHz, good for 10GBASE-T across a full 100 metre channel. That makes it a sensible choice for 10G switch uplinks, NAS boxes and multi-gig Wi-Fi access points.
The cable uses a braided outer screen plus foil around every pair (S/FTP), the heaviest screening used on copper patch leads. For the screen to do its job, pair it with shielded panels, keystones and switch ports. Its LSZH sheath (low smoke zero halogen) limits smoke and toxic fumes if there is a fire, and is often a requirement in offices, schools and hospitals. 26 AWG conductors keep the lead slimmer and more flexible than a 24 AWG cable. The RJ45 latch is protected by snagless boots, which stop it hooking on other cables or breaking.
PoE ready: it can carry power alongside data to cameras, access points and VoIP handsets under IEEE 802.3af, 802.3at and 802.3bt (PoE++), up to 90W at the switch.
Use it for tight patching inside a rack, where a longer lead would only end up coiled behind the equipment. Choosing red leads for one job (cameras, phones or uplinks, say) makes faults quicker to trace later.
Specification
- Cable category: CAT6A
- Length: 0.3m
- Colour: Red
- Screening: S/FTP
- Conductor size: 26 AWG
- Sheath: LSZH
- Boots: Snagless
- Plugs: RJ45 to RJ45
- Power over Ethernet: Up to 802.3bt (PoE++)
- Bandwidth: 500MHz
