A 1.5m CAT6A Ethernet patch lead rated to 500MHz, good for 10GBASE-T across a full 100 metre channel. That makes it a sensible choice for 10G switch uplinks, NAS boxes and multi-gig Wi-Fi access points.
The cable uses a braided outer screen plus foil around every pair (S/FTP), the heaviest screening used on copper patch leads. For the screen to do its job, pair it with shielded panels, keystones and switch ports. An LSZH (low smoke, zero halogen) jacket is used, which is what most building specifications now call for indoors. Using 26 AWG copper makes it a little thinner and easier to dress neatly than heavier-gauge leads. Snagless boots shield the RJ45 clip, so it will not catch when the lead is pulled through a bundle or snap off in use.
It supports Power over Ethernet up to IEEE 802.3bt (PoE++), so one cable powers and connects IP cameras, wireless access points and desk phones.
Handy at a desk or TV cabinet, and long enough to patch across a rack or to the next cabinet along. Red is one of several colours in the range, so you can colour-code by department, VLAN or device type.
Specification
- Cable category: CAT6A
- Length: 1.5m
- Colour: Red
- Screening: S/FTP
- Conductor size: 26 AWG
- Sheath: LSZH
- Boots: Snagless
- Plugs: RJ45 to RJ45
- Power over Ethernet: Up to 802.3bt (PoE++)
- Bandwidth: 500MHz
