This 0.5m CAT6A patch lead from Nimbus is rated to 500MHz and handles 10GBASE-T across a full 100 metre channel. That makes it a sensible choice for 10G switch uplinks, NAS boxes and multi-gig Wi-Fi access points.
The cable uses a braided outer screen plus foil around every pair (S/FTP), the heaviest screening used on copper patch leads. Screened leads work best when the switch ports and patch panel are screened as well. Its LSZH sheath (low smoke zero halogen) limits smoke and toxic fumes if there is a fire, and is often a requirement in offices, schools and hospitals. Using 26 AWG copper makes it a little thinner and easier to dress neatly than heavier-gauge leads. Snagless boots shield the RJ45 clip, so it will not catch when the lead is pulled through a bundle or snap off in use.
It supports Power over Ethernet up to IEEE 802.3bt (PoE++), so one cable powers and connects IP cameras, wireless access points and desk phones.
It is sized for in-rack patching between a panel and the switch directly above or below it. Green is one of several colours in the range, so you can colour-code by department, VLAN or device type.
Specification
- Cable category: CAT6A
- Length: 0.5m
- Colour: Green
- Screening: S/FTP
- Conductor size: 26 AWG
- Sheath: LSZH
- Boots: Snagless
- Plugs: RJ45 to RJ45
- Power over Ethernet: Up to 802.3bt (PoE++)
- Bandwidth: 500MHz
